How bad is it? Scratch in barrel extension

Fightingfish

Fightingfish

.40 S&W
Messages
206
Reaction score
212
Location
Long Island
Upon inspection after an expensive hour at the range, I noticed a scratch in my barrel extension. It very well could have been there when I bought the barrel. Is this problematic in an accuracy/reliability sense? It’s in the roughly 11 o’clock position in this phot.
 

Attachments

  • 7ABE923D-7ADE-41F9-9410-71529FAFAEEF.jpeg
    7ABE923D-7ADE-41F9-9410-71529FAFAEEF.jpeg
    91.6 KB · Views: 64
Uzi

Uzi

.308 Win
Messages
2,978
Reaction score
3,292
Location
Phoenix, Arizona
It's probably not going to be an issue, but you might want to try to apply a small amount of Neosporin over the scratch now to be safe. You'll want to avoid any iron oxide formation which can infect the barrel if the exposed area contacts salts from the burnt powder residue. Wait a week and let it form its own protective oxide layer with the antiseptic, and it should be fine. Do make sure the dust cover is closed while waiting so dirt won't get in the area as well.
 
kev74

kev74

20×102mm Vulcan
Messages
45,587
Reaction score
143,838
Location
Orange Co.
Uzi said:
It's probably not going to be an issue, but you might want to try to apply a small amount of Neosporin over the scratch now to be safe. You'll want to avoid any iron oxide formation which can infect the barrel if the exposed area contacts salts from the burnt powder residue. Wait a week and let it form its own protective oxide layer with the antiseptic, and it should be fine. Do make sure the dust cover is closed while waiting so dirt won't get in the area as well.
Click to expand...
No bandaid??? :idk:

:ROFL:
 
Fightingfish

Fightingfish

.40 S&W
Messages
206
Reaction score
212
Location
Long Island
Uzi said:
It's probably not going to be an issue, but you might want to try to apply a small amount of Neosporin over the scratch now to be safe. You'll want to avoid any iron oxide formation which can infect the barrel if the exposed area contacts salts from the burnt powder residue. Wait a week and let it form its own protective oxide layer with the antiseptic, and it should be fine. Do make sure the dust cover is closed while waiting so dirt won't get in the area as well.
Click to expand...

So I expected this thread to go one of two ways when I posted it.
A: “that’s pretty bad, you should replace before firing again for these reasons...”
Or
B: the way it went.

I appreciate y’all, lol.
Thing is a tack driver, though! I wanted to sight in a new red dot, and it was shooting crummy old Federal 55g like a laser. Made me look much better than I really am.
 
You must log in or register to reply here.
Top