3D Printing Gun Accessories

kev74

kev74

20×102mm Vulcan
Messages
45,526
Reaction score
143,549
Location
Orange Co.
I'm looking for some sources for shooting or gun stuff to 3D print.

I've been looking on thingiverse, but seems like they don't have anything shooting related.
 
Uninformed and Compliant

Uninformed and Compliant

.450/400 Nitro Ex
Messages
12,894
Reaction score
48,257
Location
CNY
kev74 said:
Da-ym!! I was hoping for earmuff clips, magazine holders and muzzle guides. You may have uped my expectations!!! :salute:
Click to expand...

Note that I would *never* print any of this stuff.
But if I did, I'd notice if there is, or is not a notch for a forward assist to go, if you have an upper that has one.
And if your upper does have one, you'll not be able to pivot the upper on the front pin, unless you carve out that notch to allow the assist-knob to clear.

And CERTAINLY, do not look at this modular lower and start giggling your ass off.
The Firebolt 3D Printable AR-15/9/45 Lower Receiver System, CTRL+Pew
 
Uninformed and Compliant

Uninformed and Compliant

.450/400 Nitro Ex
Messages
12,894
Reaction score
48,257
Location
CNY
Briwesk85 said:
I printed a full working AR15 lower. Took rounds with no problem, but the buffer tube tower was a point of failure and even with a U bolt, it still cracked. I gave up on it, because I didn’t want to fall into that dark side of guns. So now I just print speed loaders.
Click to expand...

That modular Firebolt that I linked helps with that, since it's just that one piece to print. It basically becomes a maintenance item.

Other option is to look at using a different material - if your hotend can do 260, some type of PA6 (nylon) will open up a whole new world. BUT, you need to manage the moisture with a dehydrator or such.

You'll want a hardened tip for this, but,
CarbonX™ PA6+CF (Gen3)
 
B

Briwesk85

.40 S&W
Messages
127
Reaction score
178
Location
Orange County
Uninformed and Compliant said:
That modular Firebolt that I linked helps with that, since it's just that one piece to print. It basically becomes a maintenance item.

Other option is to look at using a different material - if your hotend can do 260, some type of PA6 (nylon) will open up a whole new world. BUT, you need to manage the moisture with a dehydrator or such.

You'll want a hardened tip for this, but,
CarbonX™ PA6+CF (Gen3)
Click to expand...

oh for sure. with 100% infill and many outer walls, PLA+ wasnt going to hold up with the buffer tower. Now nylon, or PETG might hold up much better, but like i said, idk if i want to go into that territory with 3d printed lowers, so I just didnt pursue it further
 
You must log in or register to reply here.
Top