David D
.40 S&W
Any of you guys/gals have any data on loading Wadd Cutters for 44 sp/mag? Not much data out there.
44 sp/mag Wadd Cutter Loads
- Thread starter David D
- Start date
Robin
.475 A&M Magnum
I had a S&W model 24 .44 Sp. years ago, another great gun that I let slip away. I reloaded for it using cast lead semi wad cutters with gas checks, I don't remember the powder, maybe Blue Dot. Long time ago but I do remember I was in the low-end .44 mag zone and the gunned and load were awesomely accurate. I'll call my son and see if my notes were with all the stuff I gave him.
Robin
Robin
David D
.40 S&W
I have regular wad cutter, not semi.
Robin
.475 A&M Magnum
Hmmmm, I think the load data would vary more by bullet weight than configuration. All my notes are gone. I was using the RCBS manual, circa 1980, and the Hornady manual as cross-reference. At the time I was using Unique and Blue Dot for all my pistol loading.
You really should have a manual, and two is even better.
Robin
You really should have a manual, and two is even better.
Robin
David D
.40 S&W
I have manuals but there are no wadd cutter recipes
kev74
20×102mm Vulcan
What weight bullets are you using?
Robin
.475 A&M Magnum
That is from my old manual.
I did find this. 44 special wadcutter loads
Hope this helps, go slow start low.
Robin