CGW Reduced Trigger Pull Striker & Spring for CZ P10

[togmaster]

Finally got around to installing my new CGW striker and spring along with another HBI trigger in my P10

Reduced Trigger Pull Striker & Spring - Cajun Gun Works

CGW tool steel striker and reduced power striker spring. Maintains reliable ignition while simultaneously dropping the stock 5-6 pound pull down to 3.5 to 4.0 pounds. NOTE: This striker is "cut" differently than our 10300, thus producing a lighter break. Both use the same tool steel base...

cajungunworks.com

Pre travel is butter smooth almost no creep and a clean break at right around 3.5 lbs.(don't have a trigger pull scale but my best guess). Seems to work as advertised. I'll be at the range sometime this week to give it a workout. Rainy days are good for something.

 

[togmaster]

Got to the range the other day but only had enough time to run about 200 rounds through the new set up. So far function is 100% using 115 gr. Federal brass cased and Wolf steel cased ammo. Haven't had time to reload lately but I don't expect any problems with my home made stuff as it is more reliable than factory ammo.

The trigger is noticeably lighter than the stock spring/striker combo. It absolutely helps with speed and accuracy. I will definitely use this combo for USPSA and steel matches this winter. As far as carry use, I'm not sure yet. While I don't expect any problems, I'll have to live with it for a few thousand more rounds before deciding to bet my life on it.