Crossbreed Reckoning holster. G43xMOS

[Doc8404]

Maybe I’m just used to the original CB supertuck design.

I expected to be able to easily have all three fingers grasp the grip when drawing or holstering. Middle finger jams the kydex.

Also, seems like there is too much leather near the beaver tail so you can not get a proper high grip on the initial draw.

Called them. Sent pics at their request.

 

[Justincase]

I have the same holster. I trimmed the area near the trigger guard with a Dremel. Made all the difference. Now my middle finger can get a good grip up high right below the guard. Had to trim a bit of leather there too

 

[Saltwater60]

I have the same holster for my 365 and I have the same issue. I cut it with an exacto knife and burnished the leather. I trimmed to to fit the back of my gun and and my hand perfectly. Then someone turned me onto Bradec holsters and I use that now. Way better holster and way cheaper. Crossbreed kind of pissed me off since I wrote review giving it 2-3 stars and they whitewashed it. I tried again and they refuse to post my review. I’m done with them. If they can’t handle some criticism and fox an issue then fuck them. They use the same leather blank for every gun I’m guessing and they don’t bother to take time to trim it to pocket a few extra dollars.
Here’s the Bradec. I removed a tiny bit of material at the trigger guard for a better grip but took mere minutes with a dremel.

 

[Doc8404]

I like the dual clips.
I have an old Crossbreed SuperTuck for the PPS and made it fit the Glock.
But I should’ve gone with the MiniTuck.

 

[Doc8404]

Swapped for the mini tuck.
Happy now.

 

[Glock_USA]