pjzwtl
.308 Win
I know Phazer may have just pushed me over the edge. Crap there is an empty tank in the basement just looking for a purpose
Home Hydrographic Printing (or Hydro Dipping)
- Thread starter Phazer
- Start date
Eddie Gunks
.338 Win Mag
Not really. Cerekote is far better. We did one for a customer that uses his rifle for 3 gun. It is showing signs of failing.
Dont get me wrong. All in all it is good, just not nearly as tough as cerekote.
For a light use firearm/hunting rifle that are gently handled it would be fine.
It seems that the factory rifles with prints are a bit tougher as well.
Phazer
.450/400 Nitro Ex
Of this I have no doubt. This build is a range toy for the wife. It'll get around 5 coats of clear lacquer. So, for traveling to the range in a bag, it'll probably hold for awhile. I certainly wouldn't try to compare it to a serious coating treatment.
Phazer
.450/400 Nitro Ex
Assembled 9mm rifle (though, not the best lighting):
Eddie Gunks
.338 Win Mag
You forgot to dip the grip!
Phazer
.450/400 Nitro Ex
No I didn't. The wife wanted black accents to stabilize the very complex pattern.
Marine Cpl
.577 Tyrannosaur.
I bet the real grip is dipped!
Robin
.577 Tyrannosaur.
Don't set it down in the woods, you may never find it again!!! Nice job, really cool!!!!
Robin
Robin
Phazer
.450/400 Nitro Ex
Finally, ready to be sighted in at the range:
Not too shabby!
Turned out real nice, good job Phazer!
Turned out real nice, good job Phazer!
pjzwtl
.308 Win
Crap I just made the mistake of showing my wife your project, guess I will be giving it a try weather I want to or not. Not to shabby Phazer looks good!!
Phazer
.450/400 Nitro Ex
Once the 9mm was done, the wife decided that her MSR would look better with cheetah fur print. So, here it is:
(Same optic setup as on 9mm)
- Bushnell TRS-25 red dot (w/ 0.83" riser)
- Vortex 3x magnifier
- Ace ARFX-E stock
(Same optic setup as on 9mm)
- Bushnell TRS-25 red dot (w/ 0.83" riser)
- Vortex 3x magnifier
- Ace ARFX-E stock
Last edited: