Lancer magazine recall L5AWM

[freddy]

Even the best make mistakes: L5AWM “3/15” Follower Notice

Recall only if mag follower was manufactured March 2015.

...L5AWM magazine, it may contain a non-conforming follower. The non-conforming followers, which were manufactured below the allowable limit of tolerance, could fail to lock the bolt back after the last round has been fired in a small percentage of rifle platforms.​

 

[Podmonkey]

This went out a while ago, none of the ones I have seem to be affected. I'm buying more Pmags anyway, they work with stripper clips, the Lancers technically do but not very well. It caused me problems at my class, problems the Pmag did not have. The Lancers work fine hand loaded though so I'll be keeping them.

 

[freddy]

This went out a while ago, none of the ones I have seem to be affected. I'm buying more Pmags anyway, they work with stripper clips, the Lancers technically do but not very well. It caused me problems at my class, problems the Pmag did not have. The Lancers work fine hand loaded though so I'll be keeping them.

Did not know that about the stripper clips. Thank you.

 

[twisted]

I have 4 MFT mags that do the same thing. The follower rides just forward enough that it does not catch the bolt catch tang. Has anyone else experienced this with MFT mags? BTW, its not the gun as this happens with all my ARs, and P-mags work fine.