Reverse thread slip on fake suppressors

[ArmedCorgi]

I've been looking for one of these for my AR9 in 1/2 x 28 thread. So far the only ones I'm seeing are 1/2 x 36. I have about three inches of barrel sticking out from the handguard and I haven't really found a muzzle device I like. They would all just add length to the barrel. The slip over fake suppressors would make it look like the barrel is shorter and would add girth. You know we all like girth. Any one have a line on a company that makes one for 9mm in 1/2 x 28 thread? Thanks.

 

[ArmedCorgi]

Never mind, I'm an idiot, lol.

 

[Jem45472]

Somehow missed this, but if you are looking, I bought on from here.

Barrel Shrouds - Kineti-Tech

 

[ArmedCorgi]

Somehow missed this, but if you are looking, I bought on from here.

Barrel Shrouds - Kineti-Tech

Those look cool! I bought a Guntec one after I came to my senses that I could just use the 5.56 one. I completely forgot the opening of the shroud would be the same 1/2".

 

[Jem45472]

Ok, I saw the ar9 part in your post. I had to buy a 1/2x28 for 9mm. You sure the muzzle end is big enough, 556 is too small for a 9mm build.

 

[ArmedCorgi]

Ok, I saw the ar9 part in your post. I had to buy a 1/2x28 for 9mm. You sure the muzzle end is big enough, 556 is too small for a 9mm build.

The muzzle of my 9mm barrel sticks right out of the opening of the shroud. The muzzles of both 5.56 and 9mm with 1/2 × 28 threads would be the same size, 1/2". The bore of the 5.56 would just be .22 caliber instead of 9mm. Just means less barrel material at the threaded end of the 9mm.

 

[ArmedCorgi]

Ok, I saw the ar9 part in your post. I had to buy a 1/2x28 for 9mm. You sure the muzzle end is big enough, 556 is too small for a 9mm build.