Ummm, fumes?...asking for a friend...
Is there an indoor-safe equivalent?
if the appliance tag tells you watts .. there you go just add them up ..
if it just says voltage and amps ... Volts X Amps = watts
then just add a few more watts for start up draw ( peak ) ..
PS .. i'm in a trailer park .. my main breaker is only 50 amps ..
not all appliances run at the same time .. its a give and take .
washer and dryer , NG furnace , window ac 5000btu , lights frige ..
gas stove ..
so house is fed 220v via a 50A breaker ... so to fully run on a genny at the min 11000 watts
but remember that 220 is split into 120 for most items in the home .. normal home the dryer may need 220 .. mine is 120 .. same with everything .. nothing on 220 .. i could probley run a 4500 genny and power the whole house ..
Anybody use one of these small generator/inverters? Like the Honda EU2200, Yamaha, Ryobis? Suitcase sized 50+- lbs? Will it run fridges and a/c?
Talk to me . . .
Thx
When the genny is running just be diligent about monitoring your appliance usage and breaker settings. ie: when fridge compressor is running and actively cooling, shut down other large draw circuits. Conversely, after the fridge compressor shuts off and you don't open the fridge doors, shut the fridge circuit and open other circuits you might need. When you open the fridge door shut other circuits and open the fridge circuit to recool the fridge.
That's just one example of actively utilizing your service panel.
On topic... I would say the EU 2000 would run a fridge or AC unit separately. you could look up voltage draws on each and do some calculations.
When the genny is running just be diligent about monitoring your appliance usage and breaker settings. ie: when fridge compressor is running and actively cooling, shut down other large draw circuits. Conversely, after the fridge compressor shuts off and you don't open the fridge doors, shut the fridge circuit and open other circuits you might need. When you open the fridge door shut other circuits and open the fridge circuit to recool the fridge.
That's just one example of actively utilizing your service panel.
Funny you mention that. The Ryobi has an app via Bluetooth that monitors power consumption, fuel level and right ntime remaining as well as being able to shut it off remotely.That would be a great smart phone app if I wasn't so paranoid.
Just looked at the fridge here, a 28 cuft, 8.5 amp. Should be pushing 1100 watts if what Acer says holds, plus the start up. Running fridge or ac . . . Better than nothing!i have a few of the honda 2200i generators at work. we use them for some heavy duty tools. it should run a fridge, some lights and a tv IMO.. But do your math to make sure.
So, I actually just watched a video for the Predator 3500 from harbor freight. It was actually quieter than the Honda 2000 even with a 1400W load.
Just went and found it.
as for the person looking for something inside. A thought would be a good bank of deep cell batteries, and an inverter. Also could throw in a solar panel to help recover the batteries. Also a battery charger would be needed once power is back on to bring the batteries back up.
bank of batteries in side and a jenny outside and a battery charger hooked to the bank also .. remember to ventilate the hydrogen gas
This is what I am thinking for our house we just bought in FL. I'm sure I'll be bringing the old but never used one back down but I think the smaller one would get more use and actually be easier with a little forethought, especially with a transfer switch.