WTB Wanted: 10/22 Parts

[kev74]

I’m looking for some 10/22 parts - trigger group, barrel, bolt, stock.

I’m going to be doing some experimenting (I.e. Bubba-ing - cutting, reshaping, etc.) so long neglected take-off parts are preferred. If it says Volquartsen, Kidd, Clark or similar on it, its probably not what I’m looking for.

Thanks!

 

[whauburger]

I'll try and look tomorrow I may have a trigger group sitting round.

 

[dean3690]

still experimenting with this? I have a crappy factory barrel with the sight cuts in the barrel so far off that the sights can't be zeroed. Shoots fine and has some surface rust from sitting in the wrong place. I will be replacing the barrel if you are interested in the old one.

 

[FRANKIE]

still experimenting with this? I have a crappy factory barrel with the sight cuts in the barrel so far off that the sights can't be zeroed. Shoots fine and has some surface rust from sitting in the wrong place. I will be replacing the barrel if you are interested in the old one.

Sight cuts off on an original factory barrel?

 

[dean3690]

Built on a Friday afternoon just before the holiday weekend I guess. Got it at the state fair. Was a piece of junk cheap blued with a composite stock. Stove piped like heck from the start. Had to polish the inside of the receiver, polish and reshape the bolt, changed out the firing pin, extractor and the recoil spring. Now it cycles fine with any ammo, but the original sights are terrible and new sights using the factory cut on the front and the top drill on the receiver for a new rear sight do not line up. Back sight is adjusted to the max and still can't get a zero. Barrel cut for the front sight is off as the barrel is properly seated to the receiver.

 

[kev74]

still experimenting with this? I have a crappy factory barrel with the sight cuts in the barrel so far off that the sights can't be zeroed. Shoots fine and has some surface rust from sitting in the wrong place. I will be replacing the barrel if you are interested in the old one.

I'm good on barrels for now. I was able to pick up a few from someone on another forum. Thanks for asking though!

 

[dean3690]

Perhaps I'll put it on the Free page.

 

[Acer-m14]

i got a factory ruger 10/22 stainless somewhere here from my dads estate ..

he put the archangel mods on it and from the safe act i had to remove all that and dinged up the barrel surface some removing it ..

no front sight on it .. no clue where that went to .. its hiding in a corner of the house some where LOL .

found it ..

dang phone camera .. the stock is wood tone green ..

 

[kev74]

If anyone has a crappy stock they want to get rid of, let me know!

 

[Kozak]

I have a pink hogue over molded stock... don't ask lol

 

[4WHLDRFTN]

If anyone has a crappy stock they want to get rid of, let me know!

are going to albany? I have some nice origs

 

[dsdmmat]

https://www.gunbroker.com/item/945355336