The usage of strobe is usually unneeded. Your light is either on or off, no benefit to worry about getting it into strobe mode. Most lights have some weird order of button presses to activate the strobe mode. Some require you to press buttons on each side of the weapon light...whoever thought of that is a jackass. You want me to worry about activating not just one button but now two on opposite sides of the light when in a stressful situation when faced with a possible deadly encounter?! Because you have absolutely zero reason to use strobe while searching. Other lights require you to press the bottom twice in fast succession to activate strobe. Another annoying thing to work with because now you’re light is going through different modes over and over. Let’s say you’ve now pressed it twice to get into strobe. After being in strobe mode you decide you want to now go to constant high so you let go of the switch and press it fast again...you’ve now just reactivated strobe again. You have to actually completely let go of the button for a predetermined set of time by the light manufacturer to allow it to default back to high mode. NOW...let’s say you are in constant high and want to go to strobe. So you think you’ve pressed it twice but you actually pressed it three on accident and now you’ve entered low mode on accident. All those modes are annoying to work around while searching. If you do it long enough I think you’ll realize that you wish you had a high mode only light.I would think the strobe would be a bit disorienting. Bright light only slightly bother my eyes, if I look into a strobe it bothers my eyes quite a lot.