$299.99 Chinese SKS
- Thread starter Podmonkey
- Start date
GOYABEAN
.950 JDJ
probably the ugliest ones left in country 
speedkills27
6.5 Creedmoor
wait three days these will be going for 499.99
gun_slinger_boy
.338 Win Mag
I wanna wait for the next "amazing" deal.
Twogunwilly
6.5 Creedmoor
good deal, buy 3
ManrisFrack
.223 Rem
GOYABEAN
.950 JDJ
Paperpunch
.40 S&W
Ugly is ok as long as the bullets come out the front.
Blimey
.450/400 Nitro Ex
They do come out the front hole.
Just make sure you get all that cosmoline out. It's a bitch but it will make a bigger mess if you don't. It will be oozing out of the stock for some time.
@thewheels
.308 Win
Patience and a heat gun should get the stock pretty clean.
ManrisFrack
.223 Rem
I'll probably try the garbage bag method. Only heat gun I've got is the wife's hair dryer.
What does everyone use on milsurps for lube and corrosion protection? I usually use FrogLube on everything. There's a couple issues with that though - it tends to get gummy over time and it doesn't play well with petroleum based stuff. I would imagine cosmoline will be seeping out of this thing for years to come so I don't think FrogLube is going to be a great choice.
What does everyone use on milsurps for lube and corrosion protection? I usually use FrogLube on everything. There's a couple issues with that though - it tends to get gummy over time and it doesn't play well with petroleum based stuff. I would imagine cosmoline will be seeping out of this thing for years to come so I don't think FrogLube is going to be a great choice.
@thewheels
.308 Win
Hairdryer would work too. For anything metal, I strip it down and drop it in a rubbermade tub of nearly boiling water and scrub the stubborn stuff with an old toothbrush when the water cools a little.
After cosmoline removal, I've used Breakfree CLP on a few and if it's got a chrome lined bore, Pro Shot copper solvent in the tube.
Twogunwilly
6.5 Creedmoor
A lot of heat in the sun, take it out for a tan and wipe the sweat off her.
E the massive
.308 Win
Get a steam machine, then you can shoot corrosive ammo without a worry. I thank me for reminding me to get me a steamer.
Vapor
.308 Win
I had one of these beat to hell chi coms.
it shot about 8 moa...maybe ten.
I hope yours is better. I sold it for about what I paid for it ($250)
it shot about 8 moa...maybe ten.
I hope yours is better. I sold it for about what I paid for it ($250)
Marine Cpl
.577 Tyrannosaur.
I just boiled the metal parts. Afterwards with tongs, I took out each individual metal piece and sprayed it with Wd40 after it cooled a bit. Wiped it down and that’s it. The job was over. Put it back together again.