CVA BP 50 cal .. never cleaned .. need help ..
- Thread starter Acer-m14
- Start date
I know they make a foaming cleaner. Maybe try a few rounds of that. Good luck and keeps us informed.
Acer-m14
20×102mm Vulcan
yeah i know there is lots of cleaners out there .. all i have on hand is Hopps #9 and soap n water ..
My father uses the foaming kind. He says it does a good job but I'm not very well versed to BP to know if it's true.
kev74
20×102mm Vulcan
Make sure its unloaded before you start.
When I clean mine, I take the nipple off, take the stock off of the barrel, and put the breech end in a bucket. Then I'll pour boiling hot water from a tea kettle down the muzzle until there's enough water in the bucket to cover where the nipple screws in. Then I'll work the barrel with a brush or jag while the breech is submerged so it sucks water in and out through the hole. After that, a rinse with more boiling hot water. Then I'll swab the bore with Bore Butter.
Good luck!
When I clean mine, I take the nipple off, take the stock off of the barrel, and put the breech end in a bucket. Then I'll pour boiling hot water from a tea kettle down the muzzle until there's enough water in the bucket to cover where the nipple screws in. Then I'll work the barrel with a brush or jag while the breech is submerged so it sucks water in and out through the hole. After that, a rinse with more boiling hot water. Then I'll swab the bore with Bore Butter.
Good luck!
kev74
20×102mm Vulcan
I'd still try super hot water first. Its supposed to dissolve the harmful salts in the black powder residue. Ammonia might help too. It also works on cleaning some salts and metal oxidzes.
Robin
.577 Tyrannosaur.
I don't know anything about inlines. He was probably using those modern pellets and they will rot a steel barrel pretty quick, probably stainless too. At this point I would try hot water and Dawn detergent suds up real well and soak it in that, then a good scrubbing with a quality copper bore brush. After that, see what you got and proceed.
Robin
Robin
JohnD13
.357 mag
Plug the breech, fill barrel with evapo-rust, let it sit for 24 hours. Pour out more sludge then you might think, then clean with hot water and soap, dry and oil it.
kev74
20×102mm Vulcan
Post some before and after pics. I'm interested to see how whatever you try works.
1075tech
.338 Win Mag
I had a similar situation with a CVA inline. Couldn't even see down the barrel. Used almost a whole can of the foaming bore cleaner and many, many patches.
There is still one dark spot in the rifling. But it shoots.
There is still one dark spot in the rifling. But it shoots.
Acer-m14
20×102mm Vulcan
Sixbennetts
.45 acp
I think the used that gun on the Mayflower.
kev74
20×102mm Vulcan
You weren't kidding!
Acer-m14
20×102mm Vulcan
Duke
.357 mag
Like I tell the liberals, nothing in life is free....good luck and I hope you get it done....now I have to go check mine....
kev74
20×102mm Vulcan
That's a lot better!