1075tech
.338 Win Mag
Anyone here know anyone, preferably "close" to the 12550, that can drill and tap a bolt carrier? I'm looking to make my SCR a side charger.
Looking 4 Someone to Drill and Tap BCG
- Thread starter 1075tech
- Start date
1075tech
.338 Win Mag
I am aware of that.
Yes. But I want to do that with the SCR. The bolt carrier is what needs to be drilled and tapped for the handle and since the SCR bolt carrier is proprietary, that's what I need drilled.
kev74
20×102mm Vulcan
Do you have dimensions? And what thread size?
1075tech
.338 Win Mag
Not yet. Looking for someone who can do it first
kev74
20×102mm Vulcan
I can drill and tap. If you can find out what size the screw holes need to be, I can let you know if I have the right size drill and tap.
1075tech
.338 Win Mag
Will do. Thanks
I probably have them if you dont.
tony
.223 Rem
Is the carrier hardened?
kev74
20×102mm Vulcan
I've been doing some research. While I'm always game to try, it seems like some of the BCGs are a PITA to drill and tap.
Bear Creek Arsenal has a stripped side charging carrier for less than $40.
www.bearcreekarsenal.com
Bear Creek Arsenal has a stripped side charging carrier for less than $40.
Search results for: 'bca stripped side charging bolt carrier'
Bear Creek Arsenal manufactures the largest selection of affordable quality AR-15 and AR-10 Firearms, Uppers, Lowers, Barrels, Assemblies, and more!
www.bearcreekarsenal.com
1075tech
.338 Win Mag
Yes. From my understanding, the carrier is hardened. Not being a metalurgist and not knowing the proper tools and methods, I figured someone here might know.
I'm heading south for work this week so I'll look into it more next weekend. Thanks guys.
I'm heading south for work this week so I'll look into it more next weekend. Thanks guys.
tony
.223 Rem
It is probably good idea to find out what the hardness is. Generally, if it is below Rc 38 on the Rockwell "C" scale it is machinable with high speed steel cutting tools. It will be tough but doable if your set-up is good and rigid and your tools sharp. The lower the number the easier it is to machine.
Looking at the BCA carrier ad Kev74 posted I see it is made from 8620 steel. 8620 is a "low carbon" alloy steel and is generally case hardened giving it a very hard skin and a softer core. You might be able to cut through the skin with a carbide drill or end mill. A rigid set-up is mandatory...
Looking at the BCA carrier ad Kev74 posted I see it is made from 8620 steel. 8620 is a "low carbon" alloy steel and is generally case hardened giving it a very hard skin and a softer core. You might be able to cut through the skin with a carbide drill or end mill. A rigid set-up is mandatory...
Last edited:
Loworange88
.40 S&W
A guy at work drilled and tapped his BCG and his was case hardened. once thru the case, it drilled and tapped just fine. I think he used a carbide drill and did it with the mill not a drill press. I have a side charge upper, ive thought about using it on my Ares but its on a dedicated lower now, so no need anymore.
FrankenCub
.338 Win Mag
Now if they had that with the bolt on the other side.....