holdover
.475 A&M Magnum
I see, I wasnt aware of the Youngs BCG. I may pick one up on the next build . What do you have for a upper reciever in the 200 250 dollar range?
i was leaning toward a Larue.
i was leaning toward a Larue.
Huh? Lol...
I'd definitely defer to @mek on these things much more experience than me....
With that said I'd try the dremel if you dont have a press or mill.
Oh I bought it like this . I was going to try to grind off the top of the weld and see if the pin is loose enough to to turn
I think both can be preserved but if you want just get a hacksaw and go to town! lolIm not worried about the brake . I can carve it up , Im not all that concerned with the barrel either. I just want to get a new barrel on it. I can get a new brake , no biggie
I mean its an older barrel , lots of rounds through it , useable but nothing great. 20 bucks for brake? No worries. And I dont need a hacksaw, I have a god dammed grinding wheel baby!
The sell muzzle breaks! Illegal in NY per SAFE!stick to standard well balanced configurations of well made parts and forget about tacticool recipes.
...if you like shiny this is an awesome group. obviously out of stock right now...
YM Standard M16 w/ HMB Bolt Complete - Young Manufacturing, Inc.
This is our standard M16 Bolt Carrier Group. As with all of our carriers we leave material on all critical areas then send them out for heat treat. Next weyoungmanufacturing.net
The sell muzzle breaks! Illegal in NY per SAFE!
Hiders / Muzzle Breaks - Young Manufacturing, Inc.
youngmanufacturing.net
Brakes are fine. NY SAFE banned breaks.Breaks illegal? how?
I installed one of those on my last upper. I don't remember any problem getting it started though. I have a set of plastic tweezers that I ground a furrow into each tip to hold the pin. I have had a pin or two on other projects where I ground a steeper taper on the tip of the pin to get it started a little better. Hope this helps, Good Luck!Ok, having trouble with gas pin . cant get it in there to save my life. is there a trick to it or maybe they sent me the wrong pin?
Odin works ajustable gas blocks
Do you have roll pin punches? It can be done without them, but it's way easier if you have a set. Once you peen over the end of the roll pin it's a PITA to start overI put a little brake free on it and used a vise grip to hold it , I got it in 3/4 of the way , and I cant get it all the way through. I tried tapping it with a small hammer , not happeneing , I dont want to mushroom the end .