Tinman
.308 Win
I have a Mossberg 590A1 that has a number of marks on the receiver. They are not scratches, but appear to be some kind of rub marks. Any idea on how to remove them? I will post pictures later.
Removing Marks
- Thread starter Tinman
- Start date
freddy
.308 Win
Last edited:
Most likely will have to get it refinished. Is the 590 parkerized?
kev74
20×102mm Vulcan
Sometimes some rubbing them with some oil on a rag will either remove or hide them.
Tinman
.308 Win
I am not sure if the receiver is or not. I will check and post pictures when I get home this evening.
Deplorable Me
.700 Nitro Express
IIRC receiver is aluminum for the Mossberg 590A1. I've touched mine up with a Sharpie, but I was just looking to mask the silver-scratch.
Good gun choice
Tinman
.308 Win
Here is a picture. Not scratches. Not sure how they got there.
Exonautic
.308 Win
Are they gouged at all? if it's just surface marks try an oiled rag. Solvent maybe? Looks almost like someone took a marker to it.
Tinman
.308 Win
No gouge at all. Smooth like something rubbed it.
I bet a plastic buckle from a sling was rubbing there. Maybe try using one of the Mr. Clean Magic erasers.
Exonautic
.308 Win
Oil first then solvent if the oil doesnt help. If neither of those help maybe a fine brush or brass wool.
Different Drummer
.44 mag
Interesting,. I have been a bit dismayed in regards to how easily the finish on my 590A1 gets messed up, even under careful use and pampering.
I have not found the treatment you seek.
Looking forward to what is suggested here.
I have not found the treatment you seek.
Looking forward to what is suggested here.
It's like the way with my mossberg patriot. I can scratch like that with my nail
Tinman
.308 Win
I will try a few of the suggestions (not the grinder) and let you know what happens.
LOL!
Robin
.577 Tyrannosaur.
Engrave the state of Michigan. If you can't pore it out, rope it in.
Robin
Robin
4excal
.338 Win Mag
I use the "Presto Pen" it's like 8$ at most sporting goods stores. It kinda works but depends on what you got going on. And I use Black Sharpies for deeper ones. Those scratches on yours seem relatively large and noticeable, these tricks aren't gonna magically make those dissapear 
GUNSICK
6.5 Creedmoor
Did it have these scratches when you bought it?
Tinman
.308 Win
No It didn't have them when I bought it. Just noticed it yesterday. Has been in the safe for awhile.
Uzi
.308 Win
Did you buy it new? If the receiver is aluminum, it's probably been hard anodized black. Nothing you can do about that because it's layered only microns thick until you hit bare metal. Otherwise it's a parkerized/nitride or similar type black oxide coating that you also won't be able to thin out without blending the texture around it. Best bet would be to recoat it most likely.
Marks are from another gun in your safe (scope,bolt handle etc..)
Tinman
.308 Win
Tried solvent with no change.
freddy
.308 Win
Maybe rubbing compound or 2000 grit sand paper?
GUNSICK
6.5 Creedmoor
Cerakote
kev74
20×102mm Vulcan
Shoe polish?
...got nothin'.
...got nothin'.